An Approach to Paracyclophane-Based Tetrathiafulvalenes: Synthesis and Characterization of a Pseudo-Geminal [2.2]Paracyclophane 1,3-Dithia-2-Thione

The synthesis of paracyclophane-based tetrathiafulvalene precursors is described in the context of the importance of these compounds in the field of material chemistry. Pseudo-geminal bis(1,3-dithia-2-thione) was synthesized via the corresponding 1,3-dithiol-2-ylium salt. The latter was obtained by a synthetic procedure that involves 4,15-bis(acetyl)[2.2]paracyclophane, a new compound of interest for many researchers.     

Improving signal-to-noise ratio for the forensic analysis of glass using micro X-ray fluorescence spectrometry

Micro X-ray fluorescence spectrometry (μXRF) is a standard technique used for the elemental analysis of glass fragments in forensic casework. The glass specimens encountered in casework are usually small (<1 mm), thin fragments that are partially transparent to the exciting X-ray beam. In addition to providing fluorescence from the small glass fragments, the primary beam X-rays can scatter within the chamber and provide noise in the measurements. To reduce scatter from the sample stage, the fragments are typically mounted on a thin plastic film and raised on an XRF sample cup (≤3 cm in height). However, at these heights, there may still be significant scatter from the sample stage, which adversely affects the signal-to-noise ratio (SNR) and the limit of detection (LOD). A plastic mount was designed and 3D-printed in-house to allow fragments to be raised as high as possible from the sample stage, thereby minimizing stage scatter. Most elements detected in glass showed an improvement in the SNR when using the 3D-printed mount for analyses. The greatest improvement (>30%) was observed for lower atomic number elements (Na and Mg) and higher atomic number elements (Sr and Zr). Another simple method to improve SNR is the use of primary beam filters; when using primary beam filters during analyses, elements with characteristic lines in the high-energy range (Rb, Sr, and Zr) showed the greatest improvement (>70%) in SNR. The impact of both strategies for the improvement of SNR is presented here.     

运用三维离散元技术模拟落锤撞击下奥克托今颗粒的点火燃烧过程

炸药颗粒的点火燃烧过程一直是人们关注的热点问题。近年来，三维离散元技术在中尺度观测颗粒材料的动力学过程中拥有显著优势。炸药燃烧属于颗粒材料的反应动力学，运用三维离散元技术(DM3)可以有效地观测炸药燃烧传播的过程。以奥克托今(HMX)颗粒为例，本文成功模拟并观测到了HMX颗粒的燃烧反应程度，确定了颗粒开始燃烧反应的时间，以及燃烧反应传播的时间。同时，结合落锤冲击颗粒的三维图像以及其表观压强和放热功率，得到了HMX颗粒燃烧反应、燃烧传播的整个反应动力学过程，包括颗粒在冲击加载下碎化塑性变形的过程，颗粒燃烧反应放热的过程，落锤回弹颗粒喷射的过程等。同时，进一步说明了尖顶颗粒更利于颗粒点火，平顶颗粒有抑制颗粒点火的能力。     

Ti0.33WO3电子结构和太阳辐射屏蔽性能第一性原理研究

节能减排已成为当今社会发展的主题,对节约能源、提高太阳能的高效综合利用的新型窗用透明隔热材料的理论设计和研究尤其重要.本文采用基于密度泛函理论的计算方法,研究了六方相三氧化钨Ti掺杂前、后的晶格参数、电子能带结构、形成能和光学性质.研究结果表明,Ti掺杂后晶格体积增大,系统能量降为负值,体系具有更好的稳定性;掺杂后电子能带结构发生很大的变化,但材料仍保持n型电导率;随之,其光学性质也发生改变,掺杂前h-WO3无近红外吸收性能,掺杂后的Ti0.33WO3具有很强的近红外吸收性能.在此基础上研究了Ti掺杂h-WO3前、后的太阳辐射屏蔽性能,掺杂前无太阳辐射屏蔽性能;掺杂后的Ti0.33WO3薄膜具有可见光高透明、近红外屏蔽的性能.计算结果为Ti掺杂h-WO3在窗用透明隔热材料方面的研究提供了理论依据.     

三维非连续变形分析方法碰撞分析及其应用

将具有完备动力学理论的非连续变形分析(DDA)方法应用于块体碰撞研究。基于三维DDA(3D DDA)方法,按时步输出块体碰撞过程速度变化和接触嵌入量,进而得到块体碰撞恢复系数、冲量、冲击力。以此为参考指标,采用斜抛、面-面对心等碰撞模型,验证3D DDA方法模拟块体碰撞的有效性,并将3D DDA方法应用于多米诺骨牌倾倒、滚石边坡成灾及防护等算例分析,探讨了多米诺骨牌倾倒机制、滚石启动及运动行为、滚石灾害防护方案。结果表明:多米诺骨牌间距越大,同一块体被碰撞时间越迟,其最终稳定时间也越迟,与下一块体碰撞的动能越大;滚石运动呈侧向平动及转动三维运动特征,每一次碰撞,均引起动能、轨迹或状态的显著变化;滚石拦挡设施弹簧刚度越大,越先达到最大冲击力,最大冲击力随弹簧刚度的增加而减小;可结合树木阻挡效应,耗散滚石动能,降低滚石飞跃高度,使滚石灾害减轻或控制在防护范围以内。     

Integrating CuO−Fe2O3 Nanocomposites and Supramolecular Assemblies of Phenazine for Visible‐Light Photoredox Catalysis

A photoredox catalytic ensemble consisting of CuO‐Fe₂O₃ nanocomposites and oligomeric derivative of phenazine has been developed. The prepared system acts as an efficient photoredox catalyst for C?N bond formation reaction via SET mechanism under ‘green’ conditions (aerial environment, mixed aqueous media, recyclable), requiring less equivalents of base and amine substrate. The present study demonstrates the significant role of supramolecular assemblies as photooxidants and reductants upon irradiation and their important contribution towards the activation of the metallic centre through energy transfer and electron transfer pathways. The potential of oligomer 4 : CuO‐Fe₂O₃ has also been explored for C?C bond formation reactions via the Sonogashira protocol.     

Magnetite nanoparticles−based hydroxyl radical scavenging activity assay of antioxidants using N,N-dimethyl-p-phenylenediamine probe

Excessive amounts of reactive oxygen species (ROS), unless counterbalanced by antioxidants, can cause cellular damage under oxidative stress conditions; therefore, antioxidative defenses against ROS must be measured. With the development of nanotechnology, nanoparticles have found numerous applications in science, health, and industries. Magnetite nanoparticles (Fe ₃ O ₄ :MNPs) have attracted attention because of their peroxidase-like activity. In this study, hydroxyl radicals (•OH) generated by MNPs-catalyzed degradation of H ₂ O ₂ converted the N,N-dimethyl-p-phenylenediamine (DMPD) probe into its colored DMPD•+ radical cation, which gave an absorbance maximum at λ = 553 nm. In the presence of antioxidants, •OH was partly scavenged by antioxidants and produced less DMPD• ⁺ , causing a decrease in the 553 nm-absorbance. Antioxidant concentrations were calculated with the aid of absorbance differences between the reference and sample solutions. The linear working ranges and trolox equivalent antioxidant capacity coefficients of different classes of antioxidants were determined by applying the developed method. In addition, binary and ternary mixtures of antioxidants were tested to observe the additivity of absorbances of mixture constituents. The method was applied to real samples such as orange juice and green tea. Student t-test, F tests, and the Spearman’s rank correlation coefficient were used for statistical comparisons.